Invert Window Sensor state for ABB EnOcean Gateway


1 min read
Invert Window Sensor state for ABB EnOcean Gateway

I use a ABB EnOcean EG/A32.2.1 EnOcean to KNX Gateway, a wonderful device, but I ran into an issue where a Eltako FTKE door window sensor (F6-10-00) reported 0 - Close; 1 - Open
And an STM 250 window sensor (D5-00-01) reports 1 = Closed; 0 -  Open.

So Home Assistant sees Window Open when magnet contact closed and visa versa.

Not wanting to fiddle with Home Assistant code this time, but it turns out that after pairing the EnOcean contact you get two status_contacts, one enabled and one disabled, if you switch them around you have a device with inverted values, happy days!

The first is with inverted instance enabled, the last the default.

Related Articles

JUNG KNX multi station
3 min read
Gira Home Server 4 on Fujitsu S720
2 min read
KNX with a power-line IP backbone
3 min read
Online KNX Resources
1 min read
Updating an GIRA 2167 00 IP Router
2 min read
My KNX RF experiences so far
4 min read

GO TOP